Lenovo THINKSERVER RD230 Manuel d'utilisateur télécharger pdf (Page 57)

5. Route the cables through the drive bay hole in the front and then slide the

optical drive into the drive bay until it snaps into position.

6. Connect the power cable to the optical drive power connector on the

backplane. See “Locating connectors on the backplane” on page 35.

7. Connect the signal cable to the SATA 5 connector on the system board. See

“Locating parts on the system board” on page 32.

8. To complete the installation, go to “Completing the parts replacement” on page

87.

Removing a hot-swap hard disk drive

Attention

Do not open your server or attempt any repair before reading and understanding the Safety

Information and the Warranty and Support Information on the ThinkServer Documentation DVD

that comes with your product, and “Guidelines” on page 37. To obtain a copy of the

publications, go to:

http://www.lenovo.com/support

This section provides instructions on how to remove a hot-swap hard disk drive.

This section applies only to server models that have hot-swap hard disk drives

installed.

Attention: To maintain proper system cooling, do not operate the server for more

than 10 minutes without either a drive or a filler panel installed in each drive bay.

To remove a hot-swap hard disk drive, do the following:

Note: You do not have to turn off the server when removing a hot-swap hard disk

drive.

Figure 15. Installing the optical drive

Chapter 5. Installing, removing, or replacing hardware 51

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 147 148

Pas de commentaire

Lenovo THINKSERVER RD230 Manuel d'utilisateur Page 57