Lenovo RD210 Manuel d'utilisateur Page 98
- Page / 204
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
If you have other options to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 111.
Removing and installing the SAS/SATA RAID riser-card assembly
To remove and install the SAS/SATA RAID riser-card assembly, complete the steps
in this section.
Removing the SAS/SATA RAID riser-card assembly
To remove the SAS/SATA RAID riser-card assembly, complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect all power cords; then,
remove the cover (see “Removing and replacing the cover” on page 43).
3. Disconnect the cables from the connectors on the SAS/SATA controller; then,
grasp the controller and pull it out of the connector on the RAID riser-card
assembly.
4. Remove the flash device from the SAS/SATA RAID riser card 1, if one is
installed.
1 SAS/SATA riser card
2 ServeRAID-BR10i controller
5. If you are instructed to return the RAID riser-card assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing the SAS/SATA RAID riser-card assembly
To install the SAS/SATA RAID riser-card assembly, complete the following steps:
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables; then, remove the server cover (see “Removing and
replacing the cover” on page 43).
3. Reinstall the SAS/SATA adapter, if one was removed.
82 ThinkServer RD210 Types 3795, 3796, 3818, and 3819: Installation and User Guide
- Installation and User Guide 1
- and User Gui de 3
- Contents 5
- Contents v 7
- Safety ix 11
- Safety xi 13
- Safety xiii 15
- Chapter 1. Introduction 17
- Related documentation 18
- Chapter 1. Introduction 3 19
- Features and technologies 23
- Specifications 26
- Software 28
- EasyStartup 28
- EasyManage 28
- Front view 31
- Operator information panel 32
- EasyLED diagnostics panel 33
- Rear view 41
- 4 Video connector 44
- System-board LEDs 49
- Power-supply LEDs 50
- System pulse LEDs 50
- Server power features 51
- Turning on the server 51
- Turning off the server 52
- Installation guidelines 55
- Removing the cover 59
- Replacing the cover 60
- 1 ServeRAID 61
- 2 SAS signal cables 61
- 2 Operator panel cable 62
- 2 Cable retention tab 63
- 3 Video cable 63
- 4 USB cable 63
- 1 Drive-tray assembly 67
- 2 Drive handle 67
- Removing an adapter 72
- Installing an adapter 73
- 1 Adapter 74
- 2 Expansion slot cover 74
- DIMM installation sequence 76
- Memory mirroring 76
- Installation steps 79
- Controller 80
- 1 SAS/SATA riser card 81
- 3 Riser card error LED 82
- 2 Microprocessor 87
- 3 Retainer bracket 87
- 4 Lock tab 87
- 3 Alignment marks 90
- Thermal grease 91
- Removing the battery 99
- Installing the battery 100
- 4 PCI riser connector 2 102
- 1 Backplane tabs 104
- 3 Backplane tabs 104
- Removing the system board 107
- Removing a CD/DVD drive 110
- Installing a CD/DVD drive 111
- Statement 3: 112
- Removing a CD/DVD cable 113
- 1 Cable connector latch 115
- 2 CD/DVD drive cable 115
- 3 Mounting tab 116
- 1 Ethernet adapter 118
- 3 Adapter bracket 118
- 2 Ethernet adapter 119
- 3 Battery 121
- 4 Release tab 121
- 1 Battery cable 122
- 4 Battery carrier 122
- 5 Battery connector 122
- Removing the bezel 124
- Installing the bezel 124
- Connecting the cables 127
- Using the Setup Utility 132
- Passwords 135
- Power-on password 136
- Administrator password 137
- Using the WebBIOS utility 141
- Using the EasyStartup DVD 143
- Setup and configuration 144
- Updating the firmware 146
- Installation requirements 150
- Installation order 151
- Diagnostic tools 157
- Error logs 158
- Clearing the error logs 159
- Troubleshooting tables 160
- EasyStartup problems 160
- CD/DVD drive problems 161
- General problems 161
- Hard disk drive problems 162
- Intermittent problems 162
- Memory problems 165
- Microprocessor problems 166
- Monitor problems 167
- Optional-device problems 169
- Power problems 170
- Serial-device problems 172
- Software problems 172
- Video problems 173
- EasyLED 173
- Remind button 174
- EasyLED switch 174
- EasyLED LEDs 175
- Power-supply diagnostics 179
- 1 AC LED (green) 180
- 2 DC LED (green) 180
- Before you call 183
- Using the documentation 183
- Calling for service 184
- Using other services 184
- Lenovo product service 185
- Appendix B. Notices 187
- Trademarks 188
- Important notes 188
- Hazardous Substances 189
- Battery return program 190
- Appendix B. Notices 175 191
- Appendix B. Notices 177 193
- Appendix B. Notices 179 195
- Index 183 199
- Index 185 201
- Part Number: 46U1926 204
- Printed in USA 204
- (1P) P/N: 46U1926 204
Produits connexes et manuels pour Ordinateurs Lenovo RD210
Ordinateurs Lenovo 3000 Manuel d'utilisateur
(26 pages)
(26 pages)
Ordinateurs Lenovo 5393 Manuel d'utilisateur
(94 pages)
(94 pages)
Ordinateurs Lenovo 6446 Manuel d'utilisateur
(112 pages)
(112 pages)
Ordinateurs Lenovo 4155 Manuel d'utilisateur
(76 pages)
(76 pages)
Ordinateurs Lenovo 5248 Manuel d'utilisateur
(98 pages)
(98 pages)
Ordinateurs Lenovo 1047 Manuel d'utilisateur
(140 pages)
(140 pages)
(9 pages)
(59 pages)© 2020, manymanuals.fr. Tous droits réservés | 3.582 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels