Lenovo RD210 Manuel d'utilisateur Page 67

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 204
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 66
v Do not mix SAS and SATA hard disk drives in the same system.
v The electromagnetic interference (EMI) integrity and cooling of the server are
protected by having all bays and PCI and PCI Express slots covered or
occupied. When you install a drive, PCI, or PCI Express adapter, save the EMC
shield and filler panel from the bay or PCI or PCI Express adapter slot cover in
the event that you later remove the device.
v For a complete list of supported optional devices for the server, go to
www.lenovo.com/thinkserver and click on the Options & Software tab.
To remove and install a hot-swap hard disk drive, complete the steps in this section.
Removing a hot-swap hard disk drive
To remove a hot-swap hard disk drive, complete the following steps.
Attention:
v To avoid damage to the hard disk drive connectors, make sure that the server
cover is in place and fully closed whenever you install or remove a hard disk
drive.
v To make sure that there is adequate system cooling, do not operate the server
for more than 2 minutes without either a hard disk drive or a filler panel installed
in each bay.
1 Drive-tray assembly
2 Drive handle
1. Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 39.
2. Slide the release latch (orange) gently to the left to unlock the drive handle.
3. Grasp the handle and slide the drive out of the drive bay.
4. If you are instructed to return the drive assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing a hot-swap hard disk drive
The following notes describe the type of hard disk drives that the server supports
and other information that you must consider when you install a hard disk drive. For
a list of supported hard disk drives, see www.lenovo.com/thinkserver.
v Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this chapter.
Chapter 5. Installing optional devices and replacing customer replaceable units 51
Vue de la page 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 203 204

Commentaires sur ces manuels

Pas de commentaire