Lenovo Computer Monitor 7098 Manuel d'utilisateur télécharger pdf (Page 137)

100

101

Replacing the primary hard disk drive

Important

When a new hard disk drive is installed, a set of Product Recovery discs might

be required. The set of Product Recovery discs enable the contents of the hard

disk to be restored to the same state as when the computer was originally

shipped from the factory. For more information on recovering

factory-installed software, refer to ″Recovering Software″ in the User Guide.

This procedure describes how to remove and replace the primary hard disk drive.

1. Remove the computer cover. See “Removing the cover” on page 117.

Note: For this procedure, it helps to lay the computer on its side.

2. Disconnect the signal and power cables from the hard disk drive.

3. Press the release tab 1 down, slide the hard drive cage 2 back, and pivot

the hard disk drive outward as shown.

4. Remove the hard disk drive cage from the chassis by simply sliding it

outward.

5. Pull on the blue handle 3 to remove hard disk drive from the drive cage.

6. Remove the failing hard disk drive from the blue plastic bracket from by

flexing the sides of the bracket enough to free it from the hard disk drive.

Chapter 9. Replacing FRUs - Tower Computers 131

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 797 798

Commentaires sur ces manuels

Pas de commentaire

Lenovo Computer Monitor 7098 Manuel d'utilisateur Page 137

Commentaires sur ces manuels

Produits connexes et manuels pour Cartes mères Lenovo Computer Monitor 7098