Lenovo THINKCENTRE 6396 Manuel d'utilisateur télécharger pdf (Page 76)

Diagnostic Error Code FRU/Action

170-197-XXX

Voltage Sensor(s) test warning

1. Make sure the component that is called

out is connected and/or enabled. See

Chapter 6, “Using the Setup Utility,” on

page 49

2. Re-run test

3. Replace the component that is called out

in warning statement

4. Replace the component under test

170-198-XXX

Voltage Sensor(s) test aborted

1. If a component is called out, make sure

it is connected and/or enabled. See

Chapter 6, “Using the Setup Utility,” on

page 49

2. Flash the system and re-test. See

“Updating (flashing) BIOS from a

CD-ROM or diskette” on page 152

3. Go to “Undetermined problems” on page

78

170-199-XXX

Voltage Sensor(s) test failed, cause unknown

1. See “Undetermined problems” on page

78

2. Flash the system and re-test. See

“Updating (flashing) BIOS from a

CD-ROM or diskette” on page 152

3. Replace component under function test

170-250-XXX

170-251-XXX

Voltage Sensor(s) Voltage limit error

1. AC/DC power adapter

2. System board

170-254-XXX

Voltage Sensor(s) Voltage Regulator Module

error

1. Voltage Regulator Module (VRM)

2. Microprocessor

3. System board

175-000-XXX

Thermal Sensor(s) Test Passed

No action

175-0XX-XXX

Thermal Sensor(s) failure

1. Flash system

2. System board

175-195-XXX

Thermal Sensor(s) Test aborted by user

Information only

Re-start the test, if necessary

175-196-XXX

Thermal Sensor(s) test halt, error threshold

exceeded

1. Press F3 to review the log file

2. Re-start the test to reset the log file

175-197-XXX

Thermal Sensor(s) test warning

1. Make sure the component that is called

out is connected and/or enabled. See

Chapter 6, “Using the Setup Utility,” on

page 49

2. Re-run test

3. Replace the component that is called out

in warning statement

4. Replace the component under test

70 Hardware Maintenance Manual

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 163 164

Commentaires sur ces manuels

Pas de commentaire