Lenovo ThinkServer RD540 Manuel d'utilisateur télécharger pdf (Page 42)

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 24

Configuring NIC Driver Parameters with QCC GUI

For information about configuring NIC driver parameters with the QCC GUI, refer to the

QConvergeConsole Help System: Setting General NIC Port Parameters and Setting Advanced NIC Port

Parameters.

Configuring NIC Driver Parameters with QCC Interactive CLI

For information about configuring NIC driver parameters with the QCC interactive CLI, refer to the

QConvergeConsole CLI User's Guide: section 7, “NIC Interactive Commands,” on the QLogic Web site

(http://driverdownloads.qlogic.com).

Configuring NIC Driver Parameters with QCC Non-Interactive CLI

Refer to the QConvergeConsole CLI User's Guide, section 4, “NIC Noninteractive commands,” on the

QLogic Web site (http://driverdownloads.qlogic.com).

VLAN Configuration

VLAN Configuration with QCC GUI

For information about VLAN configuration with the QCC CLI, refer to the QConvergeConsole Help System:

Setting Advanced NIC Port Parameters.

VLAN Configuration with the QCC Interactive CLI

For information about VLAN configuration with the QCC Interactive CLI, refer to the appropriate section in

the QConvergeConsole CLI User's Guide on the QLogic Web site (http://driverdownloads.qlogic.com).

TCP Checksum Offload IPv6 Enables and disables the TCP transmit and receive checksum offload.

Registry Key: *TCPChecksumOffloadIPv6

Default: Rx and Tx Enabled

Values: Disabled, Rx Enabled, Tx Enabled, Rx and Tx Enabled

UDP Checksum Offload IPv4 Enables and the disables the user datagram protocol (UDP) transmit and receive

checksum offload.

Registry Key: *UDPChecksumOffloadIPv4

Default: Rx and Tx Enabled

Values: Disabled, Rx Enabled, Tx Enabled, Rx and Tx Enabled

UDP Checksum Offload IPv6 Enables and disables the UDP transmit and receive checksum offload.

Registry Key: *UDPChecksumOffloadIPv6

Default: Rx and Tx Enabled

Values: Disabled, Rx Enabled, Tx Enabled, Rx and Tx Enabled

VLAN ID for Setting If the Priority and VLAN Tag is enabled, this parameter specifies a VLAN ID for this

interface (also exposed through the standard object identifier (OID)).

Registry Key: VlanId

Default: 0 (no VLAN)

Range: 0-4094

Table 2. Windows Driver Configurable Parameters (Continued)

Property Description

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 131 132

Pas de commentaire

Lenovo ThinkServer RD540 Manuel d'utilisateur Page 42