Lenovo ThinkServer RD210 Manuel d'utilisateur télécharger pdf (Page 4)

Lift the locking levers 1 on the slide rails and

push the server 2 all the way into the rack until it

clicks into place.

The cable-management arm can be installed on

either side of the server. This document shows it

being installed on the left side. To install the

cable-management arm on the right side, follow the

instructions and install the hardware on the

opposite side.

Connect one end of the support arm 1 to the

same slide rail to which you plan to attach the

cable-management arm so that you can swing the

other end of the support arm 2 toward the rack.

Install the L-shaped cable-management stop bracket

1 on the unattached end of the support arm. Turn

the bracket 2 to secure it to the support arm.

To attach the other side of the support arm to the

backside of the slide rail, pull the pin out 1, and

then slide the bracket 2 into the slide rail.

1 2 3 4 5 6 7

Pas de commentaire

Lenovo ThinkServer RD210 Manuel d'utilisateur Page 4