Lenovo 3000 Y410 Manuel d'utilisateur télécharger pdf (Page 57)

Replacing Memory

Chapter 5. Upgrading and Replacing Devices

To install an SO-DIMM, do the following:

1. Touch a metal table or a grounded metal object. This action reduces any

static electricity in your body, that could damage the SO-DIMM. Do not

touch the contact edge of the SO-DIMM.

2. Turn off the computer; then disconnect the ac adapter and all cables

from the computer.

3. Close the computer display, and turn the computer over.

4. Remove the battery.

5. Unfasten the two screws a on the cover and remove the cover b.

6. Find the notch on the contact edge side of the SO-DIMM.

Attention: To avoid damaging the SO-DIMM, do not touch its contact edge.

7. With the notched end of the SO-DIMM toward the contact edge side of

the socket, insert the SO-DIMM into the socket at an angle of about

20 degrees, then press it in firmly a.

8. Push the SO-DIMM down until it snaps into place.

Lenovo 3000Y410 UG.book Page 49 Friday, September 14, 2007 1:37 PM

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 85 86

Pas de commentaire

Lenovo 3000 Y410 Manuel d'utilisateur Page 57