Lenovo Secure Managed Client Manuel d'utilisateur télécharger pdf (Page 14)

v Reduced air flow - installation of the equipment in a rack should be such

that the amount of air flow required for safe operation of the equipment is

not compromised.

v Mechanical loading - mounting of the equipment in the rack should be such

that a hazardous condition is not achieved due to uneven mechanical

v Circuit overloading - Consideration should be given to the connection of the

equipment to the supply circuit and the effect that overloading of the circuits

might have on overcurrent protection and supply wiring. Appropriate

consideration of equipment nameplate ratings should be used when

addressing this concern.

v Reliable earthing - reliable earthing of rack-mounted equipment should be

maintained. Particular attention should be given to supply connections other

than direct connections to the branch circuit (e.g. use of power strips).

Electrical current safety information

Danger

Electrical current from power, telephone, and communication cables is

hazardous.

To avoid a shock hazard:

v Do not connect or disconnect any cables or perform installation,

maintenance, or reconfiguration of this product during an electrical storm.

v Connect all power cords to a properly wired and grounded electrical

outlet.

v Connect to properly wired outlets any equipment that will be attached to

this product.

v When possible, use one hand only to connect or disconnect signal cables.

v Never turn on any equipment when there is evidence of fire, water, or

structural damage.

v Disconnect the attached power cords, telecommunications systems,

networks, and modems before you open the device covers, unless

instructed otherwise in the installation and configuration procedures.

v Connect and disconnect cables as described in the following table when

installing, moving, or opening covers on this product or attached devices.

8 Safety and Warranty Guide

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Pas de commentaire

Lenovo Secure Managed Client Manuel d'utilisateur Page 14