Lenovo E200 Manuel d'utilisateur télécharger pdf (Page 109)

12. Lower the microprocessor retainer.

13. Lock the retainer with the small handle to secure the microprocessor in the

socket.

14. The new retention bracket has plastic one-way rings on the posts that insert

into the rear of the new system board. Install the new retention bracket by

aligning the posts on the module with the holes in the system board and

pushing the posts through the holes until the retention bracket is secure.

15. Install the heat sink and fan assembly on the new system board.

16. Install the new system board into the chassis and align the screw holes with

those in the chassis. Insert and tighten the screws that secure the system

board.

17. Connect all the cables to the system board. See “Identifying parts on the

system board” on page 85.

18. Go to “Completing the FRU replacement” on page 107.

Chapter 8. Replacing FRUs (Type 7848) 103

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 123 124

Pas de commentaire

Lenovo E200 Manuel d'utilisateur Page 109