Lenovo IdeaPad S205 Manuel d'utilisateur télécharger pdf (Page 25)

General checkout

Power system checkout

To verify a symptom, follow the steps below:

1. Turn off the computer.

2. Remove the battery pack.

3. Connect the AC adapter.

4. Make sure that power is supplied when you turn on the computer.

5. Turn off the computer.

6. Disconnect the AC adapter and install the charged battery pack.

7. Make sure that the battery pack supplies power when you turn on the

computer.

If you suspect a power problem, see the appropriate one of the following power

supply checkouts:

• “Checking the AC adapter ” on page 21

• “Checking operational charging” on page 21

• “Checking the battery pack ” on page 22

Checking the AC adapter

You are here because the computer fails only when the AC adapter is used.

If the power-on indicator does not turn on, check the power cord of the AC •

adapter for correct continuity and installation.

If the computer does not charge during operation, go to • “Checking

operational charging”.

To check the AC adapter, follow the steps below:

1. Unplug the AC adapter cable from the computer.

2. Measure the output voltage at the plug of the AC adapter cable. See the

following gure:

Voltage (V DC)

+20

Note: Output voltage for the AC adapter pin No. 2 may differ from the one you

are servicing.

3. If the voltage is not correct, replace the AC adapter.

4. If the voltage is acceptable, do the following:

Replace the system board.•

If the problem continues, go to • “Lenovo IdeaPad S205” on page 27.

Note: Noise from the AC adapter does not always indicate a defect.

Checking operational charging

To check whether the battery charges properly during operation, use a

discharged battery pack or a battery pack that has less than 50% of the total

power remaining when installed in the computer.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 80 81

Pas de commentaire

Lenovo IdeaPad S205 Manuel d'utilisateur Page 25