Lenovo THINKSTATION D10 Manuel d'utilisateur télécharger pdf (Page 34)

Replacing an adapter card

1. Turn off the computer and allow the computer to cool for ten minutes.

2. Open the computer cover. See “Opening the cover” on page 12.

3. Unlatch and open the card retainer.

4. Take note of the location of all cable connections on the adapter card. It will be

necessary to reconnect them properly when installing a new card.

5. Disconnect all cables connected to the adapter card. See “Identifying parts on

the system board” on page 9.

6. Some models have:

v A screw installed in the adapter bracket, remove this screw.

v An additional retention feature located on the card guide end. Push the

retention feature toward the front of the chassis before removing the adapter

card.

7. Release the card support retaining latches. Grasp the adapter card and pull the

card out of the slot.

Note: The card is a tight fit, so it might be necessary to remove each side a

little at a time until the card is removed from the card slot.

Figure 17. Installing an adapter card

26 ThinkStation Hardware Installation and Replacement Guide

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 57 58

Pas de commentaire

Lenovo THINKSTATION D10 Manuel d'utilisateur Page 34